ATA (Analog Telephone Adapter) Configuration

Linksys/Sipura ATA Configuration Example
STEP 1
You must first determine what IP address it received. To do this, you need to pick up the phone attached to the Line 1 jack and dial:

                         **** (four asterisks)
then dial:     110 #
and you will be told the IP address of your device (e.g. 192.168.0.100)

STEP 2
Go to any browser equipped computer on your network and enter the address:

                   http://<IP ADDRESS>/

(where <IP ADDRESS> is replaced by the address that was given to you in STEP 1.

STEP 3
Click on the "Admin Login" button near the top right side of the screen, then click on the "Line 1" tab.




STEP 4
You need to modify only a few parameters from the factory default. They are listed here:

Proxy: spotel.ca
Display Name: Enter your Full name, this will show up as part of your callerid.
User ID: Enter the SpoTel account number.
Password: Enter the SpoTel password.
Register Expires: 3600











STEP 5
To save bandwidth, you can change Line 1 "Preferred Codec" to G729a. Also change the "Use Pref Codec Only" to No. You can only do this for one line. So, if Line 1 is on G.729a, Line 2 has to be some other codec.


STEP 6
Click on the "Save Settings " button at the bottom of the form.



STEP 7
Make calls! 

Similar configuration for IAX configuration, except replacing 5060 by 569
 
These are the ports your software/device can use to connect to our services. Please do Port-forwding at your router.

SIP: 5060 UDP
RTP Range: 10001-20000 UDP
IAX2: [569 external to 4569 internal] UDP

---